Search found 3 matches

by boomhaeur
January 10th, 2017, 3:23 pm
Forum: Software and Firmware Discussion
Topic: Firmware Marlin-1.1.0-RC6 - My Latest Version
Replies: 36
Views: 4796

Re: Firmware Marlin-1.1.0-RC6 - My Latest Version

Actually RyanE you were on the right track... I'd missed un-commenting a couple of lines in the auto-leveling section and once I did that your suggestion seems to have started taking effect although now I think I've got a z-axis calibration issue as 1mm seems to move almost a cm on each increment. U...
by boomhaeur
January 10th, 2017, 2:38 pm
Forum: Software and Firmware Discussion
Topic: Firmware Marlin-1.1.0-RC6 - My Latest Version
Replies: 36
Views: 4796

Re: Firmware Marlin-1.1.0-RC6 - My Latest Version

Thanks... have played with the setting (between -5 & +5) and doesn't seem to make any difference.

I'm wondering if I've missed something when trying to enable the auto-levelling in the script. (it's not even going down to the point where the light kicks on for it)
by boomhaeur
January 8th, 2017, 3:41 pm
Forum: Software and Firmware Discussion
Topic: Firmware Marlin-1.1.0-RC6 - My Latest Version
Replies: 36
Views: 4796

Re: Firmware Marlin-1.1.0-RC6 - now running

Hi Chip, I have your firmware running fairly well now, but one problem I can't seem to change. When I run the stock firmware, the Z Axis is fine. But when I load your firmware, the Z-axis is too high by several mm, probably 3 or 4. Changing the inductive Z-sensor doesn't seem to matter-the Z-home s...

Go to advanced search