Search found 3 matches
- January 3rd, 2017, 7:01 am
- Forum: General Questions
- Topic: Printer extrusion issue with Repetier
- Replies: 2
- Views: 5388
Re: Printer extrusion issue with Repetier
Just a remote possibility but I had an issue with the connector at the extruder motor. Basically one wire was intermittently connected and would work sometimes but depending where the head traveled the motor would jump back and forth instead of turning. Just a possibility. In my case the little wire...
- January 1st, 2017, 9:09 pm
- Forum: Slic3r
- Topic: Slic3r Prusa Edition
- Replies: 0
- Views: 7418
Slic3r Prusa Edition
Anyone having luck with this? I have been using Prusa Edition for 1.31.6 for a while now. Still having trouble dialing in the Hic i3 prusa. specifically overhangs. Also sometimes it want to bridge into mid-air. Thinking about slamming $$ at simplify 3d but wanted to give this version a chance before...
- January 1st, 2017, 5:14 pm
- Forum: Software and Firmware Discussion
- Topic: Hic 3DP-08 Marlin 1.1.0 RC8
- Replies: 19
- Views: 26502
Re: Hic 3DP-08 Marlin 1.1.0 RC8
Up and running 1.1.0 RC8
Was a pain to get some of the features working due to me knowing almost nothing about Arduino prior to this printer.
So-far it has been fun but sure eating a lot of my spare time!!!
Was a pain to get some of the features working due to me knowing almost nothing about Arduino prior to this printer.
So-far it has been fun but sure eating a lot of my spare time!!!