Search found 4 matches
- November 15th, 2016, 9:14 pm
- Forum: General Questions
- Topic: elephant foot, leveling bed, zsteps
- Replies: 15
- Views: 22150
Re: elephant foot, leveling bed, zsteps
I've learnt so much over the last few days regarding my printer and thank F--k i have that elephant foot sorted mainly thanks to youtube, and now my prints look good from top to bottom over and out.
- November 11th, 2016, 9:06 am
- Forum: General Questions
- Topic: elephant foot, leveling bed, zsteps
- Replies: 15
- Views: 22150
Re: elephant foot, leveling bed, zsteps
Ok i installed Arduino 1.6.12 set the port and downloaded Marlin 1.1.0-RC7 and i couldn't see anywhere to change the axis steps so i just left everything as it was and tried to verify then upload to the printer, all seemed to verify and upload fine, But the printer would now only display 2 lines of ...
- November 10th, 2016, 10:17 am
- Forum: General Questions
- Topic: elephant foot, leveling bed, zsteps
- Replies: 15
- Views: 22150
Re: elephant foot, leveling bed, zsteps
Thank you very much for this JoelR i really do appreciate it.
This gives me some homework to get on with, but i must admit i do find it all a bit complicated and confusing witch is why ive had to ask for help.
I will see how i get on was kind of hoping i could just build the printer then use it lol
This gives me some homework to get on with, but i must admit i do find it all a bit complicated and confusing witch is why ive had to ask for help.
I will see how i get on was kind of hoping i could just build the printer then use it lol
- November 8th, 2016, 1:44 pm
- Forum: General Questions
- Topic: elephant foot, leveling bed, zsteps
- Replies: 15
- Views: 22150
elephant foot, leveling bed, zsteps
Hi everyone. Got myself a Hictop 3DP11 and i asked Hictop if they could send me the latest firmware and they sent me "Marlin_3DP08_3DP11_398.cpp.hex" i then used cura to upload it to my printer via USB. i use simply3d for slicer. nozzle diameter: 0.40 extrusion multiplyer: 1.00 extrusion w...