Search found 6 matches

by m00se
January 29th, 2017, 4:59 pm
Forum: General Questions
Topic: Ridges / Layers Wander Back and Forth
Replies: 3
Views: 6277

Re: Ridges / Layers Wander Back and Forth

WildBill - I was having the same problem, and i just installed something to help with the z wobble. So far, it's helped a lot. The ones i used you can find here I've only done a test cube so far, but I'm printing the anti-wobble things again as to hopefully get a better set (without the ridges). I'l...
by m00se
October 10th, 2016, 3:22 pm
Forum: Hardware Modifications
Topic: Replacement Control Board
Replies: 7
Views: 14216

Re: Replacement Control Board

The smoothie board looks great, and I definitely want to look into that. But...it was a little too much for me to consider at the time...especially when I'm looking for an immediate replacement. I'm looking into building a printer from scratch in the next month or two, so I will probably get one the...
by m00se
September 29th, 2016, 9:16 am
Forum: Hardware Modifications
Topic: Replacement Control Board
Replies: 7
Views: 14216

Re: Replacement Control Board

After the initial post, I went home and at my control board to see what it looked like. Well, it definitely wasn't pretty. http://i.imgur.com/lMOZaoWb.jpg?1 I ordered the new board and have been extremely happy since. It is smaller than the original board, but the screw holes are in the same place, ...
by m00se
September 25th, 2016, 4:32 pm
Forum: Software and Firmware Discussion
Topic: HIC i3 - current firmware development information
Replies: 152
Views: 241758

Re: HIC i3 - current firmware development information

Hi Rob, I've added the file to dropbox, you can download it from - Hictop Default Marlin I have the black acrylic one too. I'm not sure if it matters, but when I requested the data, they asked for a link of where I purchased the product. I'm guessing it was to see which if I had the acrylic or metal...
by m00se
September 24th, 2016, 11:25 am
Forum: Software and Firmware Discussion
Topic: HIC i3 - current firmware development information
Replies: 152
Views: 241758

Re: HIC i3 - current firmware development information

Rob, I emailed hictop support and got the firmware. I can upload it later and attach a link if you want. What they sent me won't compile, so other than the configuration.h file, it won't be any help. You would be better off with chip's.
by m00se
September 22nd, 2016, 11:40 am
Forum: Hardware Modifications
Topic: Replacement Control Board
Replies: 7
Views: 14216

Replacement Control Board

Hi everyone! New to the forums. Bought my hictop about a month ago and have been enjoying it. I noticed the connection for the hotbed was fried this morning, and am looking for a replacement. I was wondering if anyone had upgraded their control board. I was looking on amazon for a replacement, and i...

Go to advanced search