3D Printing Forum

Purchased a new Geeetech A20M. Installed the 3d touch sensor, plugged it in and my display went blank. Screen will not come on at all .Easy Print will not upload the firmware to the printer. Fails to connect!!

Found the bin file on Creality’s website but it as an older version!!

Update: power failure and printer would not boot. Boxed up and sent back!!

Thanks for all ur help!!

Found the bin file on creality’s website. But was an older version!!

Now a new problem.....the power flickered and printer will no longer boot even with bin on sd card!!

Got a bin file that worked. Had to re-wire the extruder stepper motor!! Thanks for your help!!

Correct and thank you soooo much for all your help!!

Where did you get bin file that worked???

Thanks everyone. Got the noise to stop and the printer to print, but now the extruder motor runs in reverse. The filament moves away from extruder head!! Please help!!

Got bin file updated firmware but printer still makes noise and fails to home!!

UPDATE: Printer now does nothing!! Screen backlight comes on and that's it. Firmware dose not load??

Can anyone send me the ender 5 pro *.bin file so I can upload firmware to printer??? Virtual studio code does not work for me. If anyone could use the software and post the *.bin file here would be greatly appreciated!!!

Hi, I recently purchased a Ender 5 Pro. It seems to be making a noise and failed to home error, Please reset error keeps coming up. Can you please tell me what I can do to reset the board. It is the Creality v4.4.2. Thank you for all your help. and thank you for letting on this forum!!