Search found 4 matches
- May 3rd, 2017, 2:01 am
- Forum: Special brand filaments
- Topic: Extrudr PLA Tec Black
- Replies: 49
- Views: 77853
Re: Extrudr PLA Tec Black
I'm using the buildtak flexplate. greentec sticks even better than pla. that is also why i would not use the buildtak without the flexplate directly on glass. when i tried earlier, i was not impressed as i never managed to get the prints of the buildtak surface. At the moment, i have a large roll of...
Re: 2.3 beta
Isn't there an option to disable autoscale? and i recommend to disable autoplace as well.
incremental fan speed: you can set yourself the height at which full fan speed is reached.
incremental fan speed: you can set yourself the height at which full fan speed is reached.
- October 22nd, 2016, 2:38 pm
- Forum: Ultimaker 2 / Ultimaker 2+ / Extended & Go
- Topic: PTFE coupler - Theory and practical details
- Replies: 91
- Views: 93348
Re: PTFE coupler - Theory and practical details
Absolutly, Thank you for the insight! @iltacitoduca: i don't understand what you complain about. If all the existing hotends are so bad or too expensive and you know how to make it better, then you should go and sell your hotend and become a rich person. Or you could make a prototype and demonstrate...
- June 14th, 2016, 11:34 am
- Forum: Cura
- Topic: Cura Type A
- Replies: 30
- Views: 31203
Re: Cura Type A
I have seen this type of infill in a university paper some time ago, maybe a year. I tried to find it again but had no luck so far.