Search found 6 matches
- June 25th, 2016, 11:17 pm
- Forum: Hardware Modifications
- Topic: Hictop Upgrades
- Replies: 31
- Views: 58112
Re: Hictop Upgrades
I like how you put your end stop. I need to do that one.
- June 24th, 2016, 8:07 pm
- Forum: General Questions
- Topic: MK8 MK9 Dual Extruder Upgrade
- Replies: 2
- Views: 5908
MK8 MK9 Dual Extruder Upgrade
image.jpeg Hello Everyone, I am currently working on a dual extruder setup for my Hictop Migbot Prusa i3 Plexiglas running Marlin 1.1 RC6. Have any of you done this or know of someone who has and can point me to them? I have questions on the firmware setup and what is needed. Cannot find clear info...
- May 24th, 2016, 11:11 am
- Forum: Software and Firmware Discussion
- Topic: HIC i3 - current firmware development information
- Replies: 152
- Views: 243795
Re: HIC i3 - current firmware development information
Chip
Did you perform the upgrade yet? I'm interested to hear how it goes. I'm having an issue with my sd card. It sees its in there. Has a file on it but cannot see the files to print them.
Did you perform the upgrade yet? I'm interested to hear how it goes. I'm having an issue with my sd card. It sees its in there. Has a file on it but cannot see the files to print them.
- May 24th, 2016, 10:20 am
- Forum: Software and Firmware Discussion
- Topic: HICTOP - Software
- Replies: 46
- Views: 68483
Re: HICTOP - Software
Chip where did you get both the rods an the psu?
- May 24th, 2016, 12:54 am
- Forum: General Questions
- Topic: HIC i3 - first time assembly : suggestions and mod's
- Replies: 14
- Views: 25547
Re: HIC i3 - first time assembly : suggestions and mod's
I was having some strange issues with my z axis motors. After upgrading power plug to one with a ground and power cable between psu and mks board it seems to have corrected the issue. Might should add a sticky for these upgrades.
- May 24th, 2016, 12:35 am
- Forum: General Questions
- Topic: Help with print quality
- Replies: 2
- Views: 4791
Help with print quality
image.jpeg image.jpeg I have run through updating firmware to Marlin and added suggestions from Chip which GREATLY improved print quality. Unfortunately I'm having an issue where anything that prints towards back is failing. I flipped my print around thinking it was the file was problem and same is...