3D Printing Forum

I like how you put your end stop. I need to do that one.

image.jpeg Hello Everyone, I am currently working on a dual extruder setup for my Hictop Migbot Prusa i3 Plexiglas running Marlin 1.1 RC6. Have any of you done this or know of someone who has and can point me to them? I have questions on the firmware setup and what is needed. Cannot find clear info...

Chip

Did you perform the upgrade yet? I'm interested to hear how it goes. I'm having an issue with my sd card. It sees its in there. Has a file on it but cannot see the files to print them.

Chip where did you get both the rods an the psu?

I was having some strange issues with my z axis motors. After upgrading power plug to one with a ground and power cable between psu and mks board it seems to have corrected the issue. Might should add a sticky for these upgrades.

image.jpeg image.jpeg I have run through updating firmware to Marlin and added suggestions from Chip which GREATLY improved print quality. Unfortunately I'm having an issue where anything that prints towards back is failing. I flipped my print around thinking it was the file was problem and same is...