Search found 5 matches
- July 4th, 2019, 8:17 am
- Forum: General 3D Printing Conversation
- Topic: BLTouch with Marlin doesn't print well
- Replies: 0
- Views: 9530
BLTouch with Marlin doesn't print well
Hello, As I mentioned elsewhere I have a Creality Ender 3 modified with a MKS Gen L 1.0 board. It's running Marlin 1.1.x. I have printed with this setup fine. Yesterday I got my BLTouch sensor. I printed a simple mount, installed it, and shimmed it to allow the extended BLTouch to probe the base bef...
- July 3rd, 2019, 4:54 pm
- Forum: General 3D Printing Conversation
- Topic: New Creality Ender 3, extruder stepper just wobbles?
- Replies: 6
- Views: 6887
Re: New Creality Ender 3, extruder stepper just wobbles?
The last time I had a faulty trace I just added "bodge wires" to all the traces to bypass them. I probably got lucky, it was a two layer board and a bright light showed a bad spot in it. I think at least on this product, the customer is the quality control. So I finished another 8 hr print...
- July 2nd, 2019, 9:06 pm
- Forum: General 3D Printing Conversation
- Topic: New Creality Ender 3, extruder stepper just wobbles?
- Replies: 6
- Views: 6887
Re: New Creality Ender 3, extruder stepper just wobbles?
I was able to reproduce it with the MKS Gen L!. So I did some investigation and discovered that putting pressure on the female connector for the extruder "axis" where it connects to the board can cause the extrude stepper not to work or if delicately pressed, it works fine. The original pi...
- June 30th, 2019, 3:53 pm
- Forum: General 3D Printing Conversation
- Topic: New Creality Ender 3, extruder stepper just wobbles?
- Replies: 6
- Views: 6887
Re: New Creality Ender 3, extruder stepper just wobbles?
Thanks for taking the time to reply. I ended up not troubleshooting the Creality main board. I have a o-scope, etc. but the board appears to not be serviceable. I can't solder SMD for example. I bought a MKS Gen L 1.0 board with some A4498 drivers and put Marlin on the board. It took a while to get ...
- June 19th, 2019, 7:49 pm
- Forum: General 3D Printing Conversation
- Topic: New Creality Ender 3, extruder stepper just wobbles?
- Replies: 6
- Views: 6887
New Creality Ender 3, extruder stepper just wobbles?
I bought a brand new Creality Ender 3 and assembled it today. I did some basic tests and go the bed level. After doing that, I tried to get the filament feeding. I did the PLA preheat, then tried to use the manual control to run the extruder. It didn't move the filament. I removed the filament, and ...